Air Blast Coolers
Our Air Blast Coolers/Heaters are designed to meet your process requirements. Upon receipt of your design specification we will select a suitable unit and supply you with a quotation, technical datasheet and sketch.
We also have a range of standard units available ex stock that can be us as:
Solar Panel Dump Radiators
Fan Assisted Radiant Space Heaters
Finned Tube Coil
- Copper Tubes
- Aluminium Fins
- Galvanised Steel Casing
Fan Complete with Electric Motor
Single phase 240 V motor - IP55 weatherproof rating
Class F Insulation
Fan Motor Control/Switching Panel
IP65 painted steel enclosure
Hinged door and removable gland plate and mechanically interlocked isolate switch
Hand/Off/Auto fan selector switch
Temperature controller with digital readout to set fan run and stop temperatures
Running and overload tripped LED indicating lamps
Strap-on pipe temperature sensor
PT100 temperature sensor in pocket
BMS power on/off input
BMS system running output signal
BMS fault signal
Emergency stop switch
a) Solar Panel Dump Radiators
Our range of Solar Panel Dump Radiators are designed to dissipate excess heat from solar panel installations at time of low or no demand that otherwise cause the system temperature to rise leading to potential equipment failure due to over heating.
We have a standard range of coolers from 5 kW to 45 kW comprising of a Finned Tube Coil, single phase 240v air fan and a fan motor control/switching panel that turns the fan on and off determined by temperatures set on the controller.
Each radiator is designed to cool 40% ethylene glycol/water solution from 80°C to 60°C with air at 32°C maximum.
b) Fan Assisted Radiant Space Heaters
Our range of Fan Assisted Radiant Space Heaters are for use with L.P.H.W. to provide background heat to either large or small internal spaces. The heaters provide a steady stream of fan assisted radiant hot air. They can be used to heat in-coming fresh air or re-circulated air within an enclosed space.
The outputs of the standard range are from 8.5 kW to 97 kW depending on inlet air temperature. Air flow varies from 0.24m³/sec up to a maximum of 1.6 m³/sec.
c) Oil Coolers
Oil cooling (ISO VG32) from 90° C down to 70° C in order to maintain oil viscosity in a maximum ambient air temperature of 32° C.
Four standard sizes, ranging from 4 litre/min (2.4 kW) , 6.0 litre/min (6.0 kW) , 22 Litre/min (12.8 kW) and 37 Litre/min (21.5 kW).
Outputs can be increased if lower ambient air used.
Other sizes can be selected to suit specific specifications if required.
Max working pressure / temperature of matrix: 10 bar / 175° C.
d) Custom Built Coolers
Should you require an Air Blast Cooler/Heater outside our standard range please send us you process requirements and we will design a unit to suit.